---
term: "Rockwell Hardness"
category: "material-testing"
shortDefinition: "Indentation hardness determined by measuring residual depth after a defined preliminary force, total test force, and recovery interval, expressed on scales such as HRC, HRB, and HRA."
formula: "HR = N − h / s"
relatedStandards: ["ISO 6508-1","ASTM E18"]
url: "https://vectorbtc.com.tr/resources/glossary/rockwell-hardness/"
---

The **Rockwell hardness test** is the most widely used indentation method for metals and many hardened engineering components. A spheroconical diamond indenter (for harder materials) or hardened steel ball (for softer materials) is pressed into the surface under a **preliminary force** to seat the indenter, then the **total test force** is applied for a specified dwell time. After removal of the total force, the depth of the residual indentation relative to a reference position is measured and converted to a hardness number using scale-specific constants.

Common scales include **HRC** (diamond cone, 150 kgf total force), **HRB** (1/16 in ball, 100 kgf), and **HRA** (diamond cone, 60 kgf). The choice of scale depends on expected hardness, thickness, and microstructure; standards provide minimum thickness and spacing rules to avoid anvil influence and edge effects.

Unlike Brinell or Vickers, Rockwell does not require optical measurement of impression size on production lines, which makes it fast and repeatable for QC. Automated testers apply forces via closed-loop load cells and measure depth with LVDT or encoder systems calibrated with reference blocks traceable to national hardness scales.

For thin coatings and superficial layers, **Rockwell superficial** scales (15N, 30N, 45N with 15, 30, or 45 kgf total force) reduce penetration depth. Results must always be reported with the scale symbol; converting between scales is only approximate and requires validated correlation for a given material and processing route.

Laboratories validate Rockwell systems using certified reference blocks and indirect verification procedures defined in ISO 6508-1 and ASTM E18, including daily checks before production testing.